1. Gently scratch crisscross lines on areas to be joined.
2. Using a soft brush, moisten scored areas or broken edges with water. Use the same brush to apply a good coat of Patch-A-Tatch to these areas.
3. Quickly attach or fit the pieces together and hold securely for a few seconds.
4. Brush a little Patch-A-Tatch over the joint and, when set and thoroughly dry, scrape, sand, sponge or otherwise finish, and the piece is ready for decorating or firing.
5. Clean up with water.
SY545-4 Patch-A-Tatch
WARNING: This product can expose you to chemicals including Silica, crystalline (airborne particles of respirable size), which are known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.