Mend-A-Mold Apt II 1 oz

SKU
APTII-MM
$4.10
Mend-A-Mold Apt II 1 oz
OR
The mold mender designed and formulated specifically for repairing plaster ceramic molds.
1 A one-part ready-to-use adhesive that works equally well on both wet or damp molds. Just apply Mend-a-Mold on the broken pieces and press together.
2 Apply pressure while adhesive sets - a rubber band or banding strap may used. Be sure to remove any excess adhesive from inside of mold with wet sponge. After 2-3 hours, your mold is read to use.
3 Mix together mold plaster and cold water to replace missing part of mold. (The plaster and water mixture should be equal parts by weight. Remember, powder is dry weight and water is liquid weight.) You should have approximately 5-10 minutes working time.
4 Apply a thin layer of APT-II Mend-a-Mold to area of your wet or damp mold that you need to reconstruct. Immediately apply the new plaster mix to the area. When the new plaster has set up, sculpt back detail area. NOTE: If a mold is deteriorated to the point of crumbling, no product can achieve 100% restoration

Warning WARNING: This product can expose you to chemicals including Silica, crystalline (airborne particles of respirable size), which are known to the State of California to cause cancer.  For more information go to www.P65Warnings.ca.gov.